Difference between revisions of "R2D2 Tutorial"
From GcatWiki
(→Guide) |
(→Install software on Mac) |
||
| Line 15: | Line 15: | ||
*MatLab Setup | *MatLab Setup | ||
*Python Setup | *Python Setup | ||
| − | + | #Download and Install [http://opencv.willowgarage.com/wiki/Mac_OS_X_OpenCV_Port MacPorts] | |
Revision as of 19:56, 8 May 2012
Introduction
Our project was motivated by people leaving windows open inside chambers.
Requirements
- MacOS X computer
- Needs bluetooth
- Needs MatLab and Python 2.7.3
- iRobot Create
- BAM iRobot bluetooth adaptor
- Wifi webcam that you can power
- We used Foscam FI8918W because it ran off 5 volt power, allowing us to wire it to the iRobot for power.
Guide
Install software on Mac
- MatLab Setup
- Python Setup
- Download and Install MacPorts
