Difference between revisions of "R2D2 Tutorial"
From GcatWiki
(→Install software on Mac) |
(→Install software on Mac) |
||
| Line 18: | Line 18: | ||
#Open terminal and type the following commands. | #Open terminal and type the following commands. | ||
#Install open cv for python 2.7 <pre>sudo port -v install opencv +python27</pre> | #Install open cv for python 2.7 <pre>sudo port -v install opencv +python27</pre> | ||
| + | #Install pil for python 2.7 <pre>sudo port install py27-pil</pre> | ||
| + | #Optional: Install selenium for python 2.7 <pre>sudo port install py27-selenium</pre> | ||
| + | ##Use this option if you want to control the webcam via a browser | ||
| + | #Set this MacPorts installed python as the default python interpreter: <pre>sudo port select --set python python27</pre> | ||
Revision as of 20:01, 8 May 2012
Introduction
Our project was motivated by people leaving windows open inside chambers.
Requirements
- MacOS X computer
- Needs bluetooth
- Needs MatLab and Python 2.7.3
- iRobot Create
- BAM iRobot bluetooth adaptor
- Wifi webcam that you can power
- We used Foscam FI8918W because it ran off 5 volt power, allowing us to wire it to the iRobot for power.
Guide
Install software on Mac
- MatLab Setup
- Python Setup
- Download and Install MacPorts
- Open terminal and type the following commands.
- Install open cv for python 2.7
sudo port -v install opencv +python27
- Install pil for python 2.7
sudo port install py27-pil
- Optional: Install selenium for python 2.7
sudo port install py27-selenium
- Use this option if you want to control the webcam via a browser
- Set this MacPorts installed python as the default python interpreter:
sudo port select --set python python27
