Difference between revisions of "R2D2 Tutorial"
From GcatWiki
(→Install software on Mac) |
(→Install software on Mac) |
||
| Line 16: | Line 16: | ||
*Python Setup | *Python Setup | ||
#Download and Install [http://opencv.willowgarage.com/wiki/Mac_OS_X_OpenCV_Port MacPorts] | #Download and Install [http://opencv.willowgarage.com/wiki/Mac_OS_X_OpenCV_Port MacPorts] | ||
| + | #Open terminal and type the following commands. | ||
| + | #Install open cv for python 2.7 <pre>sudo port -v install opencv +python27</pre> | ||
Revision as of 19:57, 8 May 2012
Introduction
Our project was motivated by people leaving windows open inside chambers.
Requirements
- MacOS X computer
- Needs bluetooth
- Needs MatLab and Python 2.7.3
- iRobot Create
- BAM iRobot bluetooth adaptor
- Wifi webcam that you can power
- We used Foscam FI8918W because it ran off 5 volt power, allowing us to wire it to the iRobot for power.
Guide
Install software on Mac
- MatLab Setup
- Python Setup
- Download and Install MacPorts
- Open terminal and type the following commands.
- Install open cv for python 2.7
sudo port -v install opencv +python27
