Difference between revisions of "R2D2 Tutorial"
From GcatWiki
(→Install software on Mac) |
(→Install software on Mac) |
||
| Line 13: | Line 13: | ||
==Guide== | ==Guide== | ||
====Install software on Mac==== | ====Install software on Mac==== | ||
| − | *MatLab Setup | + | *=====MatLab Setup===== |
*Python Setup | *Python Setup | ||
#Download and Install [http://opencv.willowgarage.com/wiki/Mac_OS_X_OpenCV_Port MacPorts] | #Download and Install [http://opencv.willowgarage.com/wiki/Mac_OS_X_OpenCV_Port MacPorts] | ||
Revision as of 20:04, 8 May 2012
Introduction
Our project was motivated by people leaving windows open inside chambers.
Requirements
- MacOS X computer
- Needs bluetooth
- Needs MatLab and Python 2.7.3
- iRobot Create
- BAM iRobot bluetooth adaptor
- Wifi webcam that you can power
- We used Foscam FI8918W because it ran off 5 volt power, allowing us to wire it to the iRobot for power.
Guide
Install software on Mac
- =====MatLab Setup=====
- Python Setup
- Download and Install MacPorts
- Open terminal and type the following commands.
- Install open cv for python 2.7
sudo port -v install opencv +python27
- Install pil for python 2.7
sudo port install py27-pil
- Optional: Install selenium for python 2.7 (use this option if you want to control the webcam via a browser)
sudo port install py27-selenium
- Set this MacPorts installed python as the default python interpreter:
sudo port select --set python python27
- Other Terminal Setup
- Install pkill command to terminal via MacPorts
sudo port install proctools
