Difference between revisions of "Measuring Fluorescence in Bacteria"
From GcatWiki
Line 16: | Line 16: | ||
#For GFP, set Excitation wavelength = 395 nm, Emmission = 509 nm | #For GFP, set Excitation wavelength = 395 nm, Emmission = 509 nm | ||
#For RFP, set Excitation wavelength = 584 nm, Emmission = 607 nm | #For RFP, set Excitation wavelength = 584 nm, Emmission = 607 nm | ||
− | #Exitation slit = 20 | + | #Exitation slit = 5 (may try 20) |
− | #Emmission slit = 20 | + | #Emmission slit = 5 (may try 20) |
#Average time = 0.1000 | #Average time = 0.1000 | ||
#Options | #Options | ||
#Excitation filter = Auto | #Excitation filter = Auto | ||
#Emmission filter = open | #Emmission filter = open | ||
− | #PMT voltage = High | + | #PMT voltage = Medium (may try High) |
− | #Replicates = 3 | + | #Optional: Replicates = 3, change under Samples |
#Accessories | #Accessories | ||
#Well Plate | #Well Plate |
Revision as of 16:58, 8 September 2010
Measuring Fluorescence in Bacteria
This is the procedure for measuring the function of RFP and GFP in bacterial cultures.
- Inoculate 5 ml LB broth with the appropriate antibiotic in a 15 ml tube with the clone to be measured and grow overnight or up to 20 hours in shaking incubator. Be sure to also grow up cells that cannot fluoresce for use as a control.
- Centrifuge 5 min at 4000 RPM and resuspend bacterial pellet in 400 ul dH20
- Transfer 250 ul of resuspended bacteria to a well in a white microtiter plate
- Transfer 250 ul of dH20 into one of the wells for use as a blank
- Install plate reader into fluorimeter
- Username = fluorescence ; Password = password
- Choose the Cary Eclipse folder
- Choose the Advanced Reads application for the fluorimeter
- Set Up
- For GFP, set Excitation wavelength = 395 nm, Emmission = 509 nm
- For RFP, set Excitation wavelength = 584 nm, Emmission = 607 nm
- Exitation slit = 5 (may try 20)
- Emmission slit = 5 (may try 20)
- Average time = 0.1000
- Options
- Excitation filter = Auto
- Emmission filter = open
- PMT voltage = Medium (may try High)
- Optional: Replicates = 3, change under Samples
- Accessories
- Well Plate
- Click Well Plate Reader
- Auto Zero
- Select wells
- Click OK
- Insert plate, Notch matches up to corner
- Click Start
- Ignore Data Save Warning
- After measuring with the fluorimeter, transfer each of the samples to a clear microtiter plate and measure A600 on the microtiter plate reader